Software Transfer Data

DIY : Downloader ATMEGA8

This is simple project for build by yourself ATMEGA8 downloader, which can connected to PC Dekstop/ Computer

1. Prepare severals component, are:
i. Hole PCB (10cm x 7cm)
ii. Pin header single
iii. Port Serial (Female)
iv. Capasitor Electrolit 100uF (10V~15V), capasitor non-electrolit 0.1uF (code : 101)
v. Resistor
vi. Voltage Regulator 5Volt DC LS7805
vii. IC Programmeable ATMEGA8 + socket
viii. ICSP cable
ix. Baterai holder AAx4
x. LED small size (3mm)

2. Soldering one by one every part, you can begin with IC socket, pin header, etc. ~ up to fisnih. Use the picture below to get circuit diagram explainations (Right click, Save As):

3. You can use USB-to-Serial Cable or Serial Cables when connecting to the PC/ Dekstop computer

4. AVR Studio 4 is standard usefull program to begin learn & compile then download data to IC.

Please download and install in this order:
1 AVR Studio, version 4.13, build 528 (73.8Mb)
2 AVR Studio 4.13 SP1 (build 557) (37Mb)
3 AVR Studio 4.13 SP2 (build 571) (45Mb)
4 AVR Studio v4.14 build 589 (89Mb)
Go here to download the latest AVR Studio software.